 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| MOTOROLA SEMICONDUCTOR TECHNICAL DATA Order this document by MHW2707/D The RF Line UHF Silicon FET Power Amplifier Designed for 7.5 volt UHF power amplifier applications in industrial and commercial equipment primarily for hand portable radios. * Specified 7.5 Volt Characteristics: RF Input Power: 1 mW (0 dBm) RF Output Power: 7 W Minimum Gain (Vcont = 7 V): 38.5 dB Harmonics: - 40 dBc Max @ 2 fo * Meets European Transient Specification (ETS 300 113) * Epoxy Glass PCB Construction Gives Consistent Performance and Reliability * 50 Input/Output Impedances * Guaranteed Stability and Ruggedness MHW2707-1 7W 403-440 MHz UHF POWER AMPLIFIER CASE 301AL-01, STYLE 1 MAXIMUM RATINGS (Flange Temperature = 25C) Rating DC Supply Voltage (Pins 2, 4, 5) DC Control Voltage (Pin 3) RF Input Power RF Output Power (VDD1, 2, 3 = 9 V) Operating Case Temperature Range Storage Temperature Range Symbol VDD1, 2, 3 Vcont Pin Pout TC Tstg Value 9 7 2 9 - 30 to +80 - 30 to +80 Unit Vdc Vdc mW W C C REV 1 MOTOROLA RF (c) Motorola, Inc. 1997 DEVICE DATA MHW2707-1 1 ELECTRICAL CHARACTERISTICS (VDD1 = VDD2 = VDD3 = 7.5 Vdc (Pins 2, 4, 5); TC = +25C, 50 ohm system unless otherwise noted) Characteristic Frequency Range Control Voltage (Pout = 7 W; Pin = 1 mW) (1) Quiescent Current (VDD1 = VDD2 = VDD3 = 7.5 Vdc; Pin = 0 mW, Vcont = 0 Vdc) Power Gain (Pout = 7 W, Vcont = 7 Vdc) Efficiency (Pout = 7 W; Pin = 1 mW) (1) Harmonics (Pout = 7 W; Pin = 1 mW) (1) Input VSWR (Pout = 7 W; Pin = 1 mW, 50 Ref.) (1) Control Current (VDD1= VDD2 = VDD3 = 7.5 Vdc; Pin = 1 mW) (1) Load Mismatch Stress (VDD1 = VDD2 = VDD3 = 9 Vdc; Pin = 2 mW; Pout = 9 W; Load VSWR = 10:1, All Phase Angles at Frequency of Test) (1) Stability (Pin = 1 - 2 mW; VDD1 = VDD2 = VDD3 = 6 - 9 Vdc; Pout = between 0.1 mW and 9 W; Load VSWR = 8:1, All Phase Angles at Frequency of Test) (1) (1) Adjust Vcont for Specified Pout. 2 fo Symbol BW Vcont -- Gp -- VSWRin Icont -- Min 403 0 -- 38.5 40 -- -- -- Max 440 7 1 -- -- -40 2:1 2 Unit MHz Vdc mA dB % dBc -- mA No Degradation in Output Power Before & After Test All Spurious Outputs More Than 60 dB Below Desired Signal MHW2707-1 CIRCUIT BLOCK DIAGRAM 1 C1 C2 2 C2 3 C2 4 5 C3 C2 6 L1 Z1 C1 RF INPUT VDD1 Vcont L1 L1 L1 Z2 C1 VDD2 C1 VDD3 C1 RF OUTPUT Pin Designations: Pin 1 -- RF Input Power (0 dBm) Pin 2 -- VDD1 (7.5 Vdc) Pin 3 -- Vcont (0 - 7 Vdc) Pin 4 -- VDD2 (7.5 Vdc) Pin 5 -- VDD3 (7.5 Vdc) Pin 6 -- RF OUT (7 Watts nom.) Element Values: C1 = 0.018 F C2 = 0.1 F C3 = 3.3 F L1 = 0.22 H CHOKE Z1 = Z2 = 50 Microstrip Line Figure 1. UHF Power Module Test Circuit Schematic and Device Block Diagram MHW2707-1 2 MOTOROLA RF DEVICE DATA TYPICAL CHARACTERISTICS 8 , EFFICIENCY (%) Vcont , CONTROL VOLTAGE (Vdc) 7 6 5 4 3 2 1 0 400 405 410 VSWR 415 420 425 430 f, FREQUENCY (MHz) 435 440 VCont Pin = 1 mW Pout = 7 W VDD1 = VDD2 = VDD3 = 7.5 Vdc 50 45 40 12 11 10 Pout , OUTPUT POWER (W) 9 8 7 6 5 4 3 2 1 0 Pin = 1 mW VDD1 = VDD2 = VDD3 = 7.5 Vdc f = 420 MHz 403 MHz 440 MHz 2.0:1 1.5:1 1.0:1 445 INPUT VSWR 1 2 3 4 5 VCont, CONTROL VOLTAGE (Vdc) 6 7 Figure 2. Control Voltage, Efficiency and VSWR versus Frequency Figure 3. Output Power versus Control Voltage 12 10 Pout , OUTPUT POWER (W) 8 6 VDD1 = VDD2 = VDD3 = 6 Vdc 4 2 0 400 Pin = 1 mW VCont = 7 Vdc 405 410 420 415 425 430 f, FREQUENCY (MHz) 435 440 445 Vcont , CONTROL VOLTAGE (Vdc) VDD1 = VDD2 = VDD3 = 7.5 Vdc 6.4 6.2 6 5.8 403 MHz 5.6 5.4 5.2 5 -30 -20 -10 10 20 30 40 50 0 TC, CASE TEMPERATURE (C) 60 70 80 Pin = 1 mW VDD1 = VDD2 = VDD3 = 7.5 Vdc Pout = 7 W f = 440 MHz Figure 4. Output Power versus Frequency Figure 5. Control Voltage versus Case Temperature 9 8 Pout , OUTPUT POWER (W) 7 6 5 4 3 2 1 0 -30 -20 -10 10 20 30 40 50 0 TC, CASE TEMPERATURE (C) 60 70 80 Pin = 1 mW VDD1 = VDD2 = VDD3 = 7.5 Vdc VCont SET FOR Pout = 7 W @ TC = 25C f = 403 MHz Pout , OUTPUT POWER (W) 440 MHz 12 10 8 6 4 2 Pin = 1 mW VDD1 = VDD2 = VDD3 = 7.5 Vdc VCont = 7 Vdc f = 403 MHz 440 MHz 0 -30 -20 -10 0 10 20 30 40 50 60 70 80 TC, CASE TEMPERATURE (C) Figure 6. Output Power versus Case Temperature Figure 7. Output Power versus Case Temperature at Maximum Control Voltage MOTOROLA RF DEVICE DATA MHW2707-1 3 PACKAGE DIMENSIONS -Z- -A- G -B- -S- 1.02 (0.040) M TA R K M NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2. CONTROLLING DIMENSION: INCH. 3. DIMENSION F TO CENTER OF LEADS. 4. REF INDICATES NON-CONTROLLED DIMENSION FOR REFERENCE USE ONLY. DIM A B C D E F G H J K L N P Q R S V X X INCHES MIN MAX 1.760 1.780 1.370 1.390 0.245 0.265 0.017 0.023 0.080 0.100 0.132 BSC 1.650 BSC 1.290 BSC 0.266 0.280 0.230 0.300 1.090 BSC 1.190 BSC 0.010 REF 0.118 0.132 0.535 0.555 0.445 0.465 0.590 BSC 0.790 BSC 0.390 BSC RF INPUT VDD1 VCONT VDD2 VDD3 RF OUTPUT GROUND MILLIMETERS MIN MAX 44.70 45.21 34.80 35.31 6.22 6.73 0.43 0.58 2.03 2.54 3.35 BSC 41.91 BSC 32.77 BSC 6.76 7.11 5.84 7.62 27.69 BSC 30.25 BSC 0.25 REF 3.00 3.35 13.59 14.10 11.30 11.81 14.99 BSC 20.07 BSC 9.91 BSC J 123 4 56 Y D 6 PL TBM W X L N H Q 2 PL 0.20 (0.008) M TS M A M 0.33 (0.013) M F E C -T- P 6 PL 0.25 (0.010) SEATING PLANE M T STYLE 1: PIN 1. 2. 3. 4. 5. 6. CASE: CASE 301AL-01 ISSUE O Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. "Typical" parameters which may be provided in Motorola data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including "Typicals" must be validated for each customer application by customer's technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. Mfax is a trademark of Motorola, Inc. How to reach us: USA / EUROPE / Locations Not Listed: Motorola Literature Distribution; P.O. Box 5405, Denver, Colorado 80217. 303-675-2140 or 1-800-441-2447 JAPAN: Nippon Motorola Ltd.: SPD, Strategic Planning Office, 4-32-1, Nishi-Gotanda, Shinagawa-ku, Tokyo 141, Japan. 81-3-5487-8488 MfaxTM: RMFAX0@email.sps.mot.com - TOUCHTONE 602-244-6609 ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park, - US & Canada ONLY 1-800-774-1848 51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852-26629298 INTERNET: http://motorola.com/sps MHW2707-1 4 MHW2707/D MOTOROLA RF DEVICE DATA |
Price & Availability of MHW2707-1
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |